你知道吸油煙機該怎樣清洗維護嗎？

發布人：http://www.hkcts.com.cn   發布時間：2018-11-13 11:15:45

相信大家家里都有吸油煙機吧，隨著科技的發展吸油煙機也成了家中很普遍的東西，然而長時間使用油煙機上面就飄著一層油漬，吸油煙機的表面和內腔會充滿油污，影響其正常排煙效果，只有正確地拆洗才能正常使用。山東通風管道的小編今天給大家整理一篇不帶有過濾網罩的吸油煙機清洗方法：

Believe that everyone has a smoke machine at home, with the development of science and technology, smoke machine has become a very common thing in the home, but long-term use of smoke machine on the top of a layer of oil stains, smoke machine surface and internal cavity will be full of oil stains, affecting its normal smoke exhaust effect, only the correct removal and washing can be used normally. Xiaobian is going to clean up a hood cleaning method without filter screen.

1、切斷吸油煙機的電源，以確保人身。

1, first cut off the power supply of hood, to ensure personal safety.

2、吸油煙機的外殼表面和網罩一般按說明書規定的周期進行清洗，采用軟布沾有少量的放有中性洗滌劑的溫水進行擦洗。再用干的軟布擦干。

2. The shell surface and mesh cover of the hood are usually cleaned according to the period specified in the manual, and a small amount of warm water with neutral detergent on the soft cloth is used for scrubbing. Dry with a soft cloth.

3、風輪和蝸殼內腔的拆洗：

3. The washing and washing of the inner cavity of the wind wheel and the volute.

（1）擰開網罩蓋板和網罩的螺釘，取下蓋板和網罩。

(1) unscrew the cover of the net cover and the net cover, and remove the cover plate and net cover.

（2）然后再擰開風輪的緊固螺釘，取出風輪。

(2) then unscrew the fastening screws of the wind wheel and take out the wind wheel.

（3）將取出的零件放在有中性洗滌劑的溫水中浸泡，用軟布洗凈后擦干。

(3) soak the removed parts in warm water with neutral detergent, rinse with soft cloth and dry.

（4）用帶有少量放有中性洗滌劑的溫水的軟布擦洗蝸殼內腔里的污垢，用軟布洗凈后擦干；

(4) Wash the dirt in the inner cavity of the volute with a soft cloth with a small amount of warm water containing neutral detergent, and then dry it with a soft cloth.

（5）依拆卸的相反順序?qū)⒁陨细鞑考b好；

(5) install the above parts in the reverse order of disassembly;

（6）安裝好以后，檢查器具的油路是否順暢和蝸殼上的密封圈是否能密封；

(6) after installation, check whether the oil circuit of the instrument is smooth and whether the sealing ring on the volute can be sealed.

（7）請按說明書規定的周期清洗風輪、蝸殼、通油嘴和排油管。

(7) please clean the wind wheel, volute, oil nozzle and drain pipe according to the prescribed period.

4、清洗葉輪和蝸殼需要的注意事項：

4, cleaning impeller and spiral case need attention:

（1）清洗時，電機和電氣部分不能進水。

(1) when cleaning, the motor and electrical parts can not be flooded.

（2）清潔時，不能用力拉扯內部連接線，否則會使連接點松脫，造成觸電危險。

(2) When cleaning, do not pull the internal connection force, otherwise it will loosen the connection point and cause electric shock hazard.

（3）禁止用酒精、香蕉水、汽油等易燃溶劑清洗吸油煙機，以防火災事故的發生。

(3) It is forbidden to use flammable solvents such as alcohol, banana water and gasoline to clean the lampblack suction machine in order to prevent fire accidents.

（4）清洗時，應戴上橡膠手套，以防金屬件的銳邊傷人。

(4) when you wash, you should wear rubber gloves to prevent sharp edges of metal parts from hurting people. 

（5）拆下的零件要輕拿輕放以免變形，清洗葉輪時特別小心，不可觸碰或挪動葉片的配重塊，否則，會造成整機振動，噪音增大。

(5) Removal of parts should be handled lightly to avoid deformation. Particular care should be taken when cleaning impellers. The counterweight blocks of blades should not be touched or moved. Otherwise, the vibration and noise of the whole machine will be increased.

對于那些帶有過濾網罩的吸油煙機，由于油煙進入器具內部以前已經過過濾，所以其內部的結構不需要進行清洗，只需要按說明書規定的周期清洗器具外殼和過濾網罩就可以了。

For those smokers with filter screen cover, because the smoke has been filtered before entering the inside of the appliance, the internal structure of the smoke absorber does not need to be cleaned, only the shell of the appliance and the filter screen cover need to be cleaned periodically according to the instructions.

吸油煙機的內部電氣連接和氣流密封部位不宜經常拆洗。密封圈經常拆洗容易導致老化變形，油污容易進入器具電氣連接部位，影響其性能，降低吸油煙機的使用壽命。今天的新聞就更到這了如果你還想了解更多的油煙機的信息請點擊我們的網站：http://www.hkcts.com.cn謝謝！

The internal electrical connection and airflow seal parts of the hood are not always cleaned. Seal ring often disassembled and washed easily lead to aging and deformation, oil pollution easy to enter the electrical connection parts of appliances, affecting its safety performance, reducing the service life of the hood. That's all for today's news. If you want to know more about the range hood, please click on our website: http://www.hkcts.com.cn. Thank you!