辦公樓大型通風管道的清洗方法？

發布人：http://www.hkcts.com.cn   發布時間：2020-10-21 14:22:41

辦公樓大型通風管道的清洗方法？

Cleaning method of large air duct in office building?

1、對空調通風管道系統進行分層清洗，然后將每層空調管道系統分成若干個清洗施工管段，每段長度不超過30米。

1. First of all, the air conditioning and ventilation duct system is cleaned by layers, and then each layer of air conditioning pipeline system is divided into several cleaning construction pipe sections, each section length is not more than 30 meters.

2、將檢測機器人和其他成套設備聯機工作，檢測機器人從檢測風管內的口添加到檢測口，以檢測風管內部的污染情況，通過監控?cái)z像單元可以從顯示的風管內部的污染情況和整個視頻檢測過程中看到，并隨時填寫一些相關記錄。

2. The detection robot and other complete sets of equipment work online. The detection robot is added from the port in the air duct to the detection port to detect the pollution inside the air duct. Through the monitoring camera unit, the pollution situation inside the air duct and the whole video detection process can be seen, and some relevant records can be filled in at any time.

3、對于小型空調和通風系統的風管，用電動毛刷清理一切，彎曲段和立管的通風，用空氣或軟毛刷清理空氣噴嘴，其清理和清潔工具應與大型電動吸塵器配合使用，以保證風管內的灰塵和雜物能被有效地吸出。

3. For the air duct of small central air conditioning and ventilation system, use electric brush to clean everything, ventilate bending section and riser, clean air nozzle with air or soft brush. The cleaning and cleaning tools should be used together with large-scale electric vacuum cleaner to ensure that dust and debris in the air duct can be effectively sucked out.

4、立式風管清洗:立式風管一般只在空調房或通風井內，針對這種情況打開真空吸塵器底部的風管接口。在高點，用高壓鼓風機反復吹洗管子。對于坡度和落差大于38O的風管，用高壓風機按照上述方法反復吹掃風管。

4. Cleaning of vertical air duct: the vertical air duct is usually only in the air conditioning room or ventilation shaft. In view of this situation, open the air duct interface at the bottom of vacuum cleaner. At high points, repeatedly blow the pipe with a high-pressure blower. For the air duct with gradient and drop greater than 38O, the high-pressure fan shall be used to repeatedly blow the air duct according to the above method.

5、清洗質量合格后，用氣動噴霧器噴灑劑(主要由殺線蟲劑、次氯酸鈉、表面活性劑等組成)。并在風道內進行處理。

5. After the cleaning quality is qualified, the aerosol sprayer is sprayed with pneumatic sprayer (mainly composed of Nematocides, sodium hypochlorite and surfactant). Disinfection treatment was carried out in the air duct.

6、清潔后，將設備移動到下一個地方，然后重新安裝設備以清潔下一個地方。

6. After cleaning, move the device to the next location and then re install the device to clean the next place.

7、下一次清洗時，操作步驟相同，只需將安裝除塵器的風口作為風刷的入口，相鄰的下一個風口作為除塵器的連接口。將氣囊放在吸塵器的后端并密封，用另一個氣囊密封清潔的部分，以防止二次污染。

7. In the next cleaning, the operation steps are the same, just take the air outlet where the dust collector is installed as the inlet of the air brush, and the next adjacent air outlet is the connection port of the dust collector. Place the airbag at the back of the vacuum cleaner and seal it. Seal the clean part with another airbag to prevent secondary pollution.